HP OFFICEJET PRO 8025 PRINTER SETUP

The HP OfficeJet Pro 8025 printer setup involves two phases---Hardware setup and Software setup. In the hardware setup, you will unbox your printer, install the hardware components, insert the ink cartridges, and load the plain paper. In the software setup, you will install the printer software on your computer. For detailed instructions about the basic printer setup, go through the steps given below.

basic HP Officejet Pro 8025 Printer Setup

Hardware setup:

  • Start by unboxing your printer.
  • Remove the packing materials.
  • Connect your printer to a power supply.
  • Turn on your printer if it doesn't start automatically.
  • Configure your preferences on the touchscreen LCD.
  • Save the settings by touching the Confirm button.
  • Open the front door and the ink cartridge access door.
  • Unpack the cartridges and then remove the protective materials from the cartridges.
  • Insert each cartridge into the carriage.
  • Close the cartridge access door and front door.
  • Pull the paper input tray out of the printer.
  • Slide apart the paper guides.
  • Load a stack of legal plain paper into the tray.
  • Adjust the paper stack with the paper guides and refix the tray into the printer.
  • Align the print head using the alignment page and wait for the printer to show the Alignment Successful message.

You have now completed the hardware setup for your HP OfficeJet Pro 8025 printer.

Software setup:

If your printer comes with a software installation CD-ROM, insert it into your computer's CD/DVD drive and run the driver installation. Otherwise, download and install the printer driver on your computer to complete the software setup.

HP Officejet Pro 8025 Printer Installation

Installing the HP Easy Start software:

After completing the hardware setup for your HP OfficeJet Pro 8025 printer, download the HP Easy Start software from the official HP site and proceed to install it by following the steps given below.

  • Before starting, ensure that your printer is turned on.
  • Do not connect your printer to your computer until instructed during the driver installation.
  • Run the HP Easy Start software.
  • Accept the license agreements and click Next.
  • Now, connect your printer and computer via a USB cable or over a wireless network.
  • On the Printer found screen, check if your printer's name is listed.
  • If HP Easy Start fails to detect your printer, click the My Printer is Not Shown button.
  • Carry out the instructions in the setup wizard and make your printer detected.
  • Install the required software by selecting them in the driver installation wizard.
  • After installing the printer driver, print a test page and add your printer to your computer.

Driver Download

Wireless Setup

USB SETUP

Copyright © 2021 - 2022 hp-ojpro.com | All rights are reserved.